User`s guide

1–System Requirements
Software Requirements
1-2 SN0054667-00 B
The minimum requirements for a SAN environment are as follows:
 Storage. Fibre Channel or iSCSI devices, such as disks and RAID
subsystems. QConvergeConsole CLI supports most Fibre Channel and
iSCSI devices. See the QLogic Storage Networking Interoperability Guide,
which you can download from the following QLogic Web page:
http://connect.qlogic.com/interopguide/info.asp
Software Requirements
The software requirements for the server on which your adapter is physically
installed are as follows:
 QLogic adapter drivers for your operating system
 Administrative privileges to perform management functions
Operating System Requirements
QConvergeConsole CLI runs on the following platforms:
 Windows
®
Server
®
2003, Windows Server 2008
 Red Hat
®
Linux
®
Advance Server/Enterprise Server
 Novell
SUSE
®
Linux Enterprise Server (SLES)
Supported QLogic Adapters
The supported QLogic-branded adapters are as follows. For support of
OEM-branded adapters, please contact your OEM.
NOTE:
Tape devices are shown as part of the configuration, but are not fully
supported. Only persistent binding is supported.
NOTE:
Refer to the QLogic Web site for QLogic adapter drivers and agents:
http://driverdownloads.qlogic.com
.
NOTE:
For the supported operating system versions, refer to the Readme where
QConvergeConsole CLI is posted on the QLogic Web site:
http://driverdownloads.qlogic.com
.