User`s guide

6–iSCSI Noninteractive Commands
-tc (Configure Target Parameters)
6-28 SN0054667-00 B
If you only specify the <hba_port_inst> parameter, QConvergeConsole CLI
lists target information for all targets on the specified adapter port. If you specify
the optional parameter [Target ID], QConvergeConsole CLI lists information
on the specified target only. This includes both persistent and dynamic targets.
-tc
(Configure Target Parameters)
To set target parameter settings, use the -tc command. For a list of target
parameters you can configure, issue the following command:
-tc <hba_port_inst> < Target_ID > <config_name | config_alias>
<value> <config_name | config_alias> <value>
-tp
To see information stored in Flash memory about persistent targets, issue the -tp
command. If you enter only the adapter port instance number,
QConvergeConsole CLI returns information for all targets of that adapter port
instance. If you enter the optional Target ID, QConvergeConsole CLI returns
information for that target only, for example:
-tc <hba_port_inst> <Target_ID>
-ts
To see summary information about both persistent and nonpersistent targets,
issue the -ts command as follows:
-ts [hba_port_inst] [Target_ID]
-ver
(Display Program Version Information)
To view the QConvergeConsole CLI utility version, issue the -ver command as
follows:
-ver
-vpd
(Display VPD Information)
To view VPD information, if any, issue the -vpd command as follows:
-vpd <hba_port_inst>
Available VPD information varies by adapter manufacturer. QLogic adapters ship
with VPD information shown as N/A.