User`s guide

6–iSCSI Noninteractive Commands
-save (Save Host Configuration)
SN0054667-00 B 6-25
Where:
To continue, press
ENTER .
-save
(Save Host Configuration)
To save the configuration (in XML) of all adapters detected, issue the -save
command as follows:
-save <file_name>
-sbootcode
(Set Secondary Boot Target Information)
To set the secondary boot target and LUN, issue the -sbootcode command as
follows:
-sbootcode <hba_port_inst> <Boot Target> <Boot LUN>
Issuing this command saves the configuration data to an XML file portable to all
platforms supported by iSCSI. This command is not active for PPC.
For primary boot code, see “-pbootcode (Set Primary Boot Target Information)” on
page 6-21.
-sbootcodecid
(Set Alternative Client ID)
To set the alternative client ID (seven characters maximum), issue the
-sbootcodecid command as follows:
-sbootcodecid <hba_port_inst> <Alternative Client ID>
This command is not active for the PPC.
–STOP = Stop the test if a failure occurs.
–RWPAT n = Set the pattern to write to the buffer, one of the following:
n = 1 (8 bytes of 0x55h) (default)
n = 2 (8 b.0tes of 0x5Ah)
n = 3 (16 bytes of 0xAAh)
n = 4 (16 bytes of 0xFFh)
hba_port_inst = The adapter port tested.
-CNT = Used with Test Count to set the number of tests, with one test
as default.
Test Count = The number of tests to do, with one as default. Enter a num-
ber between 2–(2
31
) for more than one test.