User`s guide

6–iSCSI Noninteractive Commands
-lp
6-16 SN0054667-00 B
For example, to link a CHAP entry 9 on port 2 to target 10 with BIDI CHAP turned
on, issue the following command:
-linkchap 2 9 10 TGTBCA on
This command does not reset the adapter.
-lp
The IPv6 local prefix list is created based on prefix information from router
advertisements. Destination IP addresses containing these prefixes can be
reached directly, without going through an intermediate router.
To display the local prefix list, issue the -lp command as follows:
-lp <hba_port_inst>
-model
To view the adapter “model(s)” (board type[s]) in the system, issue the -model
command as follows:
-model
-n
(Configure iSCSI Settings)
To set to adapter iSCSI parameters for single-port adapters, issue the -n
command as follows:
-n <HBA No.> <Config Name|Config Alias> <Value>
[<Config Name|Config Alias> <Value> …]
After you issue this command, the adapter is reset.
You can repeat the <Config Name|Config Alias> <Value>
parameter set
for as many parameters as you want to configure. Table 6-3 lists these parameters
and their ranges of values.
Table 6-3. Adapter Parameters
Configuration Name Configuration Alias Value
Add Firmware Options
AFW_AutoConnect AFWAC on or off
AFW_Device_Timeout AFWDT on or off
AFW_Delayed_Ack AFWDACK on or off
ExeThrottle ET 0–32767
FirstBurstLen FB 0–32767