User`s guide

6–iSCSI Noninteractive Commands
-ipdhcp (Configure IP Settings)
6-14 SN0054667-00 B
-ipdhcp
(Configure IP Settings)
To set the adapter to get its IP address, subnet mask, and gateway from the
DHCP server, issue the -ipdhcp command as follows:
-ipdhcp <hba_port_inst> [-option]
If the adapter port had prior values set manually, the DHCP values replace them.
Where [option] includes:
-isns
(Configure iSNS Settings)
To configure the iSNS settings for QLA4010 and QLA405x, issue the -isns
command as follows:
-isns <hba_port_inst
> [iSNS IP Address] [iSNSPORT <port_number>]
If you do not specify the [iSNS IP Address] parameter, the command disables
the iSNS client on the specified adapter port.
Issuing this command resets the adapter.
C = Configure the CHAP table.
B = Configure the boot parameters (only valid when the
T [targets] parameter is also specified).
file_name = The XML file with the adapter configuration. See “-save (Save
Host Configuration)” on page 6-25).
-DISN4 = Disable IPv4 network
-IPV4DHCP = Set DHCP ON
-IP = Set IP Address
-IPNM = Set IP Netmask
-IPGW = Set IP Gateway
-DISN6 = Disable IPv6 network setup
-IPLLA = Set local link address automatically
-IPLL = Set local link address manually
-IPRA = Set IPR0 and IPR1 automatically
-IPR0 = Set routable address 0 manually
-IPR1 = Set routable address 1 manually
-IPRAA = Set router address automatically
-IPRR = Set router address manually