User`s guide

6–iSCSI Noninteractive Commands
-import (Import HBA Configuration)
SN0054667-00 B 6-13
The following shows an example of the adapter port information:
0. HBA 0 Port: 0 HBA Port Instance: 0 HBA Model: QLA4050C
HBA Serial Number: FS20525B03135FW Version: 2.2.4.45 Type: Copper
IP Address: 192.168.3.7
Alias:
iSCSI name: iqn.2000-04.com.qlogic.fs10506a02810.1
1. HBA 1 Port: 0 HBA Port Instance: 1 HBA Model: QLA4062C
HBA Serial Number: AS40637A04673FW Version: 3.0.1.18 Type: Copper
IP Address: 192.168.3.22
Alias:
iSCSI name: iqn.2000-04.com.qlogic.as10506a02810.1
2. HBA 1 Port: 1 HBA Port Instance: 2 HBA Model: QLA4062C
HBA Serial Number: AS40637A04673FW Version: 3.0.1.18 Type: Copper
IP Address: 192.168.3.38
Alias:
iSCSI name: iqn.2000-04.com.qlogic.as10506a02810.1
3. HBA 2 Port: 0 HBA Port Instance: 3 HBA Model: QLA4010
HBA Serial Number: FS20407B03135FW Version: 3.0.1.17 Type: Copper
IP Address: 192.168.3.72
Alias:
iSCSI name: iqn.1991-05.com.microsoft.steinway.qlogic.org
-import
(Import HBA Configuration)
To import an adapter configuration from a file (see “-save (Save Host
Configuration)” on page 6-25), issue the -import command as follows:
-import <hba_no_target> <hba_no_Source> [A] [F N I T C B]
<file_name>
Where:
<hba_port_inst> = The specific adapter to which the data is written
<hba_port_inst_
source>
= The file with the adapter configuration you want.
A = Configure all imported parameters (F, N, I, T, C, B).
F = Configure the firmware.
N = Configure the network parameters.
I = Configure the iSCSI name.
T = Configure the targets.