User`s guide

6–iSCSI Noninteractive Commands
-acb
SN0054667-00 B 6-3
-acb
To inquire whether the access method control block (ACB) firmware functions are
supported, issue the -acb command. In general, up-to-date firmware and driver
are required for ACB to be supported.
-addchap
(Add a CHAP Entry)
To add a CHAP entry to the persistent CHAP table, issue the -addchap
command as follows:
-addchap [-BIDI] <hba_port_inst> <CHAP Name> <CHAP Secret>
The optional parameter [-BIDI] shows that the CHAP entry is BIDI
(bidirectional). When this parameter is not specified (default), the CHAP entry is
local.
Issuing this command resets the adapter.
-arp
(Display ARP Table)
The address resolution protocol (ARP) cache keeps a record of host port
connections with other hardware (such as targets) on the network. The IP
address/MAC address pairs are dynamic entries that are removed after 10
minutes. To view the ARP table, issue the -arp command as follows:
-arp <hba_port_inst>
-b
(HBA Reset)
To reset the specified adapter after making configuration changes, issue the -b
command as follows:
-b <hba_port_inst>
-binfo
(Display BIOS/UEFI [or FCode] Information)
To display the boot-code settings for the specified adapter port, issue the -binfo
command as follows:
-binfo <hba_port_inst>
NOTE:
 Issuing this command resets both ports (0 and 1) on two-port adapters.
 You must disable boot-code mode to reset the adapter (see
“-bootcodemode (Set BIOS/UEFI [or FCode] Mode)” on page 6-4).