User`s guide

5–Fibre Channel Noninteractive Commands
-tb (Target Beacon On/Off)
SN0054667-00 B 5-35
-tb
(Target Beacon On/Off)
To start or stop flashing a target’s LED, issue the following command:
# qaucli -pr fc -tb (<hba instance> | <hba wwpn>) (<target wwpn>)
(<0 | ON> | <1 | PRESET>)
-tp
(Display Host Topology)
Use the -tp option to show the topology configuration of the host:
# qaucli -pr fc -tp | topology
Under Linux, this feature is disabled if you are using the IOCTL or sysfs (inbox)
driver.
-u
(Firmware Area Update/Save)
Use the -u option to update the firmware preload area of the adapter from a
DAT file or to save the current firmware preload area of the adapter to a DAT file.
To update the adapter firmware preload table, enter the following command:
# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) <file name>
To save the current adapter firmware preload table to a DAT file, enter the
following command:
# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) save <file name>
Where:
 <hba instance> is the adapter instance number of an adapter port.
 <hba wwpn> is the world wide port name of an adapter port.
 <file name> is the name of the firmware preload table DAT file.
NOTE:
 The <0 | ON> option flashes the LED until interrupted.
The <1 | PRESET> option flashes the LED 12 times.
 This feature is supported only on JBOD (“just a bunch of disks”) devices.
NOTE:
This option is available only for QLE2562.