User`s guide

5–Command Line Interface
migration add
ISR654606-00 A 5-13
migration add
Schedules a data migration job. You can enter a name for the data migration job
and associate it with a job group. Scheduling options include: immediately, at a
pre-defined later time, or by serial scheduling. Serial scheduling requires that you
assign a priority to the job that is used to schedule it prior to (lower priority value)
or after (higher priority value) a specific job in the serial schedule queue of data
migration jobs.
Session miguser
Example The following example shows the migration add command:
MPX200 <1> (admin) (miguser) #> migration add
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index WWPN, PortId Symbolic Name Target Type
----- --------------------------------- -------------------- ------------
0 20:78:00:c0:ff:d5:9a:05, 00-00-00 HP MSA2012fc-0 Src+Dest
1 50:00:1f:e1:50:0a:e1:49, 82-07-00 HP HSV200-1 Src+Dest
2 50:06:01:60:4b:a0:35:de, 82-03-00 DGC RAID-2 Src+Dest
3 50:00:1f:e1:50:0a:37:18, 00-00-00 HP HSV210-3 Src+Dest
Please select a Source Target from the list above ('q' to quit): 2
Index (VpGroup Name)
----- --------------
1 VPGROUP_1
2 VPGROUP_2
3 VPGROUP_3
4 VPGROUP_4
Please select a VPGroup for Source Lun ('q' to quit): 4
LUN Vendor LUN Size( GB) Attributes
--- ------ -------------- ----------
0 DGC 5.00
1 DGC 5.00
2 DGC 5.00
3 DGC 5.00