User`s guide

4–Data Migration Licenses
Applying an Array-based License to a Specific Array
ISR654606-00 A 4-7
Figure 4-5 Information Page Showing Array is Licensed
Applying an Array-based License to a Specific Array in the
CLI
To apply an array-based license to a specific array in the CLI:
If you have purchased array-based licenses and installed the licenses in the
MPX200, follow these steps to license a specific array for data migration. For
every array that is licensed, one license is consumed.
1. Open a miguser session using the following command:
miguser start -p migration
2. To apply a license, enter the following command:
set array (see “set array” on page 5-8)
3. At the prompt, Do you want to apply array license (yes/no),
enter yes.