User`s guide

4–Data Migration Licenses
Installing a Data Migration License Key
4-4 ISR654606-00 A
Figure 4-3 Add License Dialog Box
6. Click OK to close the verification dialog box.
7. Verify that the newly-added key appears in the list of keys on the Features
page, as shown in Figure 4-1 on page 4-3.
Installing a Data Migration License Key in the CLI
Follow this procedure to install a data migration license key in the CLI.
To install a data migration license key in the CLI:
1. Open a miguser session using the following command:
miguser start -p migration
2. To add the license key, enter the following command:
set features (see “set features” on page 5-6)
3. To view a list of installed data migration licenses, enter the following
command:
show features (see “show features” on page 5-49)
The following example shows the set features and show features
commands.
MPX200 <1> (admin) set features
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Enter feature key to be saved/activated: 2000800-LCWL13GAUWO5K-8-ARR-LIC