User`s guide

3–Using DMS
Rescanning Targets
3-22 ISR654606-00 A
Destination Lun Size 10.24 GB
Number of DRL Blocks 0
Rescanning Targets
To see if one or more data LUNs are exposed to the router ports from the target,
you can rescan the target ports. A rescan causes the router to create an array
entity for the target ports through which the router is able to see data LUNs.
To rescan targets in the GUI:
1. In the mpx Manager left pane, right-click the FC Discovered Targets node.
2. From the shortcut menu, click Rescan.
In the left pane under the FC Arrays node, the GUI shows the
newly-generated array entity.
Alternately, you can click Refresh two or three to rescan the targets and
generate the array entity for targets that are exposing LUNs to the router.
To rescan targets in the CLI:
1. Open a miguser session using the following command:
miguser start -p config
2. To rescan for target ports, enter the following command:
target rescan
For example:
MPX200 (admin) #> target rescan
Scanning Target WWPN 00:00:02:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 00:00:01:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 00:00:03:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 50:08:05:f3:00:1a:15:11
Target Rescan done
Scanning Target WWPN 50:08:05:f3:00:1a:15:19
Target Rescan done
Target Re-Scan completed