User`s guide

3–Using DMS
Using the Data Migration Wizard
ISR654606-00 A 3-11
Figure 3-5 Data Migration Jobs Options: Individual
6. To save the data migration job options, click Apply. Or to abandon changes
to this data migration job, click Cancel.
Scheduling an Individual Data Migration Job in the CLI
Follow these steps to schedule an individual data migration job in the CLI. (To
perform this operation in the mpx Manager instead, see “Scheduling an Individual
Data Migration Job in the GUI” on page 3-8.)
To schedule an individual data migration job in the CLI:
1. Log in to the MPX200 as guest and enter the password.
2. Open a miguser session using the following command:
miguser start -p migration
(The default password for misguser is migration.)
3. To create a migration job, enter the following command:
migration add
4. Every migration job is defined by a Source LUN and a Destination LUN. The
CLI lists the source arrays that you have previously defined and prompts you
to select one.
5. From the selected source array, the CLI lists the LUNs that have been
exposed to the MPX200 for migration, and prompts you to select one LUN.