User`s guide

3–Using DMS
Using the Data Migration Wizard
3-10 ISR654606-00 A
5. In the Data Migration Jobs Options dialog box (see Figure 3-5), specify the
job attributes as follows:
a. Under Scheduling Type, select one of the following:
 Click Start Now to start the job immediately.
 Click Schedule for Later, and then enter a Start Time and Start
Date.
 Click Serial Schedule Jobs, and then assign a priority (1–256)
in the Job Priority box, where a lower value indicates that the
job is scheduled earlier than jobs configured with higher values.
For details on Serial Schedule Jobs, see “Starting Serial
Scheduled Jobs” on page 3-18.
 Click Configure Only to configure the migration job without any
start time or priority. You may start this job at a later time. (To
start the job, select it, and then click Start. Or, from the active job
pane, right-click the job, and then click Start.)
b. In the Job Description box, enter a user-defined name to describe
this data migration job.
c. In the Group Name box, select a job group name from the list. The
group name makes it easier to view the job status on a group basis.
d. In the IO Size box, either select one of the default I/O sizes, or enter a
custom value.
NOTE:
 The mpx Manager does not allow you to drag a LUN from an array
of Source type in the right pane and drop it onto the Destination
LUN in the left pane. However, if the array type is Src+Dest, you
can drop the LUN from that array onto either a Source LUN or
Destination LUN in the left pane.
 If you attempt to drop a Source LUN from the right pane onto a
Destination LUN of a smaller size in the left pane, an error
message appears.