User`s guide

3–Using DMS
Using the Data Migration Wizard
3-8 ISR654606-00 A
To start the Data Migration wizard:
1. Start HP StorageWorks mpx Manager and connect to the MPX200 by
providing the IP address of the
MPX200.
2. Start the Data Migration wizard using one of these methods:
 On the Wizards menu, click Start Data Migration.
 In the left pane, open the Services page, and then right-click Data
Migration Jobs.
3. Select the scheduling mode as follows:
a. In the top section of the Data Migration wizard, click Options.
b. In the Migration Schedule Options dialog box, select either Schedule
in batch mode or Schedule individual job, as shown in Figure 3-3.
c. Click OK.
Figure 3-3 Migration Schedule Options: Individual Job
4. Depending on your selection in the preceding step, continue with either
“Scheduling an Individual Data Migration Job in the GUI” on page 3-8 or
“Scheduling Data Migration Jobs in Batch Mode” on page 3-15.
Scheduling an Individual Data Migration Job in the GUI
Follow these steps to schedule an individual data migration job in HP
StorageWorks mpx Manager. (To perform this operation in the CLI instead, see
“Scheduling an Individual Data Migration Job in the CLI” on page 3-11.)
To schedule an individual data migration job in the GUI:
1. Start the Data Migration wizard by following the steps specified in “Starting
the Data Migration Wizard” on page 3-7.
2. In the Migration Schedule Options dialog box, click Schedule individual
job, and then click OK.