User`s guide

3–Using DMS
Setting Array Properties
ISR654606-00 A 3-5
4. In the Security Check dialog box, enter the administrative password. (The
default password is migration.)
The mpx Manager displays an informative message indicating that the array
properties have changed.
5. Click OK to close the message box.
6. To apply the changes and update the window, click Refresh.
Setting Array Properties in the CLI
Follow these steps to change the array properties using the CLI. Note that all data
migration operations are authorized only to the migration administrator session,
miguser. For more information, see “Miguser Session” on page 5-2.
To set array properties in the CLI:
1. Log in to the MPX200 as guest and enter the password.
2. Open a miguser session using the following command:
miguser start -p migration
(The default password for miguser is migration.)
3. To access the array properties, enter the following command:
set array
4. Select a target ID by entering its index number.
5. At the prompts, modify the symbolic name, target type, or array bandwidth
for the source and destination arrays.
6. At the Do you want to apply array license (yes/no) prompt,
enter Yes (the default is No) to apply your changes.
The following shows an example of how to change the array properties in the CLI.
MPX200 (miguser) #> set array
NOTE:
The DM CLI allows you to change the Bandwidth for Migration
setting only if the Target Type is either Source or Src+Dest
Target.