User`s guide

3–Using DMS
Setting Array Properties
3-4 ISR654606-00 A
To set the array bandwidth:
1. On the Information page of the selected array, click Array Bandwidth, and
then click one of the following values:
 Slow (50 MB/s)
 Medium (200 MB/s)
 Fast (1600 MB/s)
 Throttle
2. If you select Throttle, type a value between 1 and 400 in the User Defined
Bandwidth (MB/s) box. (Figure 3-2 shows an example.) By default, the
MPX200 uses all available bandwidth.
Figure 3-2 Setting Array Bandwidth
3. To save your changes, click Save.
NOTE:
Array bandwidth is only displayed and editable if the array target type is
Source.