User`s guide

5–Command Line Interface
readjust_priority
5-60 ISR654606-00 A
readjust_priority
Modifies the priority of serial scheduled jobs. Use this feature if you have more
than 256 jobs that must be executed sequentially. This operation is allowed only if
the high priority jobs are completed, and there is room for shifting the priority
values on already configured jobs. This reduces the priority value of the last job
from 256 by the value of the priority of the currently running serial job, and makes
room to configure more serial jobs.
Session miguser
Example The following shows an example of the readjust priority command.
MPX200 <1> (miguser) #> readjust_priority
Are you sure you want to adjust the priorities of serially
scheduled jobs that haven't started (y/n): y
Priorities have been successfully re-adjusted.