Installation guide

5–Fibre Channel Over IP
Configuring FCIP
5-2 ISR651101-00 C
 Trace route and ping support
 Links up to two locations per blade, four locations per chassis (two blades)
 FICON
®
support
Configuring FCIP
To successfully configure FCIP, you need to assess both the SAN and WAN
environments. The following list is provided to support the assessment.
 Extension Port Type:
 E_Port—See “E_Port Extension” on page 5-52.2 for a description and
examples.
 F_Port—See “F_Port Extension” on page 5-7 for a description and
examples.
 If E_Port, the number of ISLs (inter-switch links):
 One
 Two
 WAN Characteristics:
 Data Rate—See “Link Data Rate” on page 5-10
 RTT (round-trip time)—See “Round-Trip Time” on page 5-9
 Quality—See “Link Quality” on page 5-10
 Firewall—See“Firewall” on page 5-12
 Available WAN Bandwidth - See “Bandwidth Limiting” on page 5-14
Table 5-1 provides space for you to write down the information that you must
obtain prior to configuring an FCIP route.