Installation guide

4–Configuration

Controlling per Host LUN Access on the iSR6200

ISR651101-00 C 4-23

Controlling per Host LUN Access on the iSR6200

The iSR6200 allows multiple iSCSI initiators to connect to a single Fibre Channel

target through a given VPG. Controlling individual LUN access for each iSCSI

host requires LUN mapping devices connected through the iSR6200.

Figure 4-18 shows that even after logging into the VPG0 iSCSI target, the host

cannot access data LUNs on the storage array. To allow the iSCSI host access to

each LUN, you must configure the iSR6200 using either the SANsurfer Router

Manager or the command line interface (CLI).

Figure 4-18 Logging into Target Before LUN Mapping

NOTE:

Before proceeding with this section, be sure you have read and understand

the previous sections of this chapter.

Host accessible LUNs

Storage Array

21:00:00:c0:dd:13:16:f8

21:01:00:c0:dd:13:16:f8

21:02:00:c0:dd:13:16:f8

21:00:00:c0:dd:13:16:f8

21:00:00:c0:dd:13:16:f9

iSR6200

Blade 1

FC1

FC2

Host Entities

Host Entity 0

21:01:00:c0:dd:13:16:f8

21:01:00:c0:dd:13:16:f9

Host Entity 1

21:02:00:c0:dd:13:16:f8

21:02:00:c0:dd:13:16:f9

Host Entity 2

21:00:00:c0:dd:13:16:f9

21:01:00:c0:dd:13:16:f9

21:02:00:c0:dd:13:16:f9

LUN 1

LUN 2

LUN 3

LUN 4

LUN 5

LUN 6

iqn.2004-08.com:isr6200.0834e00019.r1.00.20030020c2075970

Log-In