Installation guide

4–Configuration
Enabling Virtual Port Groups
4-6 ISR651101-00 C
The following example shows CLI command output using an iSR6200 blade with
3 Virtual Port Groups enabled. You can view information about the Virtual Port
Groups configured on your iSR6200 using the show vpgroups command.
iSR6200 <R1> #> show vpgroups
iSR6200 <1> (admin) #> show vpgroups
VpGroup Information
---------------------
Index 1
VpGroup Name VPGROUP_1
Status Enabled
WWPNs 21:00:00:c0:dd:13:16:f8
21:00:00:c0:dd:13:16:f9
Index 2
VpGroup Name VPGROUP_2
Status Enabled
WWPNs 21:01:00:c0:dd:13:16:f8
21:01:00:c0:dd:13:16:f9
Index 3
VpGroup Name VPGROUP_3
Status Enabled
WWPNs 21:02:00:c0:dd:13:16:f8
21:02:00:c0:dd:13:16:f9
Index 4
VpGroup Name VPGROUP_4
Status Disabled
WWPNs N/A
In the preceding examples, the second byte from the left (in bold text) denotes the
virtual port group ID, and the right-most byte (in italic text) denotes the physical
Fibre Channel port. In these examples VPGs 1 through 3 have corresponding
virtual ports with 00, 01, and 02 presented out of physical FC ports 0 and 1, with
WWPNs ending in f8 and f9, respectively.