Installation guide

3–Installation
Installing New Firmware
3-12 ISR651101-00 C
2. Open an admin session and enter the commands to set up both iSCSI ports
and the management interface. (See the iSR6200 Router CLI User's Guide
for command descriptions.)
QRouter #> admin start
Password : ******
Router (admin) #> set mgmt
………………………
QRouter (admin) #> set iscsi 1
………………………
QRouter (admin) #> set iscsi 2
………………………
Connecting Cable Devices to the Router
Connect cables to the SFP transceivers and their corresponding devices. Devices
can have SFP (or SFF) transceivers or gigabit interface converters (GBIC).
Choose the fiber optic cable with the connector combination that matches the
device being connected to the router:
 LC-type duplex fiber optic cable connectors are designed for SFP
transceivers.
 SC-type connectors are designed for GBICs.
 OM-3 connectors are designed for 10Gb ports.
Installing New Firmware
The router comes with current firmware installed. You can upgrade the firmware
from the management workstation as new firmware becomes available. You can
use either SANsurfer Router Manager or the CLI to install new firmware.
Using SANsurfer Router Manager to Install Firmware
To install firmware using SANsurfer Router Manager:
1. In the topology view, double-click the router.
2. In the Firmware Upload window, click Select to navigate to and select the
firmware to upload.
3. To begin the firmware load process, click Start.
WARNING!!
Installing new firmware disrupts the router blade connectivity because you
must reboot the router blade to activate the new firmware.