Installation guide

3–Installation
Installing the iSR6200 Router
ISR651101-00 C 3-5
Mounting the Router
You can either place the router on a flat surface or mount it in a 19-inch Electronic
Industries Association (EIA) rack. See the product specification for weight and
dimensions. Rack mounting requires a QLogic rack mounting kit; contact QLogic
for more information.
If you mount the router in a closed or multi-unit rack assembly, make sure the
operating temperature inside the rack enclosure does not exceed the maximum
rated ambient temperature.
Installing the Transceivers
The router supports a variety of SFP transceivers.
 To install a transceiver, insert the transceiver into the port and gently press
until it snaps in place.
 To remove a transceiver, gently press the transceiver into the port to release
tension, and then pull the release tab or lever and remove the transceiver.
Different transceiver manufacturers have different release mechanisms.
Consult the documentation for your transceiver.
NOTE:
The transceiver fits only one way. If the transceiver does not install under
gentle pressure, flip it over and try again.