Installation guide

3–Installation
Installing the iSR6200 Router
ISR651101-00 C 3-3
7. Install the management application (see page 3-10).
8. Start the management application (see page 3-11).
9. Configure the router (see page 3-11).
10. Cable devices to the router (Fibre Channel and iSCSI) (see page 3-12).
Pre-installation Check List
During the initial configuration process, the system prompts you to enter
information for each blade contained in the iSR6200 chassis. Use the space
provided in the following tables to record the IP addresses for each blade.
Table 3-2. Worksheet for Router Blade 1 (left) Parameters
Symbolic Name of the
iSR6200 Blade 1
Management port IP
address, subnet mask,
and gateway (if not using
DHCP)
iSCSI port 1 IP address,
subnet mask, and gateway
(GE-1)
IP address of the iSNS
server for iSCSI port 1 (if
iSNS will be enabled)
iSCSI port 2 IP address,
subnet mask, and gateway
(GE-2)
IP address of the iSNS
server for iSCSI port 2 (if
iSNS will be enabled)
iSCSI port 3 IP address,
subnet mask, and gateway
for the optional (FC3,
GE-3, or 10GE-3) port
IP address of the iSNS
server for iSCSI port 3 (if
iSNS will be enabled)
iSCSI port 4 IP address,
subnet mask, and gateway
for the optional (FC4,
GE-4, or 10GE-4) port