Installation guide

1–Introduction
iSR6200 Router Blades
ISR651101-00 C 1-13
Serial Port
The iSR6200 router is equipped with an RS-232 serial port for maintenance
purposes. Figure 1-13 shows the serial port location, which is labeled IOIOI. You
can manage the router through the serial port using CLI.
Figure 1-13 Serial Port
The serial port connection requires a standard eight-wire Ethernet cable and the
supplied dongle to convert the Ethernet RJ45 connector to a female DB9
connector. Table 1-4 defines the serial port pins for both the router’s RJ45
connector and the dongle DB9 connector.
Table 1-4. Serial Port Pin Identification
Dongle DB9
Pin Number
Router RJ45
Pin Number
Description
1 5 Data carrier detect (DCD)
2 6 Receive data (RxD)
3 3 Transmit data (TxD)
4 2 and 7 Data terminal ready (DTR)
5 4 Signal ground (GND)
6 5 Data set ready (DSR)
7 1 Request to send (RTS)
8 8 Clear to send (CTS)
9 NC Ring indicator (RI)
MGMT IOIOI
FC1 FC2 GE1 GE1
GE4 GE3 iSR6240
Intelligent Storage Router
iSR6200 System
10GbE1 iSR6250
Intelligent Storage Router
10GbE2
Serial Port