Installation guide

1–Introduction
iSR6200 Router Blades
1-10 ISR651101-00 C
 Resets the maintenance port IP address to 10.0.0.1.
 Disables the iSCSI ports and sets the IP address to 0.0.0.0.
 Erases all presentations.
 Erases all discovered initiators and targets.
Fibre Channel Port LEDs
The iSR6200 router has two Fibre Channel ports. The ports are labeled FC1 and
FC2, as shown in Figure 1-10.
Figure 1-10 Fibre Channel LEDs
The port LEDs are located to the right of their respective ports and provide status
and activity information.
Each port has three LEDs:
 The yellow LED (top) shows activity for data passing through the port at
8-Gbps speed.
 The green LED (middle) shows activity for data passing through the port at
4-Gbps speed.
 The amber (bottom) LED shows activity for data passing through the port at
2-Gbps speed.
Table 1-3 describes the LED blink patterns and their meanings.
Table 1-3. Port LEDs
Activity
Yellow LED
(8 Gbps)
Green LED
(4 Gbps)
Amber LED
(2 Gbps)
Power OFF
OFF OFF OFF
Power ON
(before firmware initializa-
tion)
ON ON ON
MGMT IOIOI
FC1 FC2 GE1 GE1
GE4 GE3 iSR6240
Intelligent Storage Router
iSR6200 System
10GbE1 iSR6250
Intelligent Storage Router
10GbE2
8Gb (Yellow)
4Gb (Green)
2Gb (Amber)