Installation guide

1–Introduction
iSR6200 Router Blades
1-8 ISR651101-00 C
Beacon Indicator (Blue)
The iSR6200 router blade’s PCB has a blue beacon light installed near the center
vent hole between the Fibre Channel ports (Figure 1-8). This light enables you to
locate the physical blade when monitoring the iSR6200 routers using the
SANsurfer Router Manager. If you enable the Beacon On option for a selected
blade in the Router Manager, the blue beacon light flashes through the vent hole
on the chassis blade’s face plate.
Maintenance Button
The maintenance button shown in Figure 1-9 is the only router blade control.
Press this button to reset the router blade or to recover it if it becomes disabled.
Figure 1-9 Router Blade Controls
The maintenance button is a multifunction momentary switch on the front panel. It
has the following functions:
 “Reset a Router Blade” on page 1-8
 “Reset and Select Boot Image” on page 1-9
 “Reset IP Address” on page 1-9
 “Enable DHCP” on page 1-9
 “Restore Factory Defaults” on page 1-9
Reset a Router Blade
To reset the router blade, use a pointed, nonmetallic tool to momentarily press
and release (less than two seconds) the maintenance button. The router responds
as follows:
1. All the router blade LEDs illuminate.
2. After about 2 seconds, the POST begins, turning off the heartbeat and
system fault LEDs.
3. When the POST is complete, the power LED is on and the heartbeat LED
flashes once per second.
MGMT IOIOI
FC1 FC2 GE1 GE1
GE4 GE3 iSR6240
Intelligent Storage Router
iSR6200 System
10GbE1 iSR6250
Intelligent Storage Router
10GbE2
Maintenance Button