Installation guide

7–Removal and Replacement
iSR6200 Chassis Blades
7-6 ISR651101-00 C
3. Use an FTP client to get the FRU file from the iSR6200 blade. For both the
user name and password, enter ftp. Remember to issue the bin
command before you issue the get command. For example:
ftp <
your router IP>
Connected to <your router IP>
220 (vsFTPd 2.0.5)
User (<your router IP>:(none)):
ftp
331 Please specify the password.
Password:
ftp
230 Login successful.
ftp>
bin
200 Switching to Binary mode.
ftp>
ls
200 PORT command successful. Consider using PASV.
150 Here comes the directory listing.
iSR6200_FRU.bin
226 Directory send OK.
ftp: 17 bytes received in 0.00Seconds 17000.00Kbytes/sec.
ftp>
get iSR6200_FRU.bin
200 PORT command successful. Consider using PASV.
150 Opening BINARY mode data connection for iSR6200_FRU.bin (20010 bytes).
226 File send OK.
ftp: 20010 bytes received in 0.00Seconds 20010000.00Kbytes/sec.
ftp>
bye
221 Goodbye.
4. Disconnect all cables from the iSR6200 blade. This includes all Fibre
Channel, Ethernet, and serial cables. You can leave the power cables
connected. (See Figure 7-5.)
NOTE:
After you have installed the new blade, you must access it. Use a
computer with a TCP/IP interface capable of using Telnet to connect to
the new blades default IP address of 10.0.0.1. Make sure you have
such a computer available before you remove your old blade, and that
the computer has the FRU file on it you saved in step 3.