Installation guide

ISR651101-00 C 7-1
7 Removal and Replacement
This chapter describes how to remove and replace the following field replaceable
units (FRUs):
 SFP Transceivers
 “iSR6200 Chassis Blades” on page 7-1
 “Power and Cooling Modules” on page 7-10
SFP Transceivers
You can remove and replace the SFP transceivers while the iSR6200 router is
operating without damaging the router or the transceiver. However, this interrupts
transmission on the affected port until you install the transceiver.
 To remove a transceiver, gently press the transceiver into the port to release
the tension, and then pull the release tab or lever and remove the
transceiver. Different transceiver manufacturers have different release
mechanisms. Consult the documentation for your transceiver.
 To install a transceiver, insert it into the port and gently press until it snaps in
place.
iSR6200 Chassis Blades
The iSR6200 router provides an enhanced facility you can use to replace any
blade in the field. In a dual-blade chassis, the iSR6200 automatically restores a
replacement blade’s configuration. When replacing a blade in the single-blade
chassis, you can use the iSR6200 router’s management tools to save and restore
a blade’s configuration.
NOTE:
The SFP transceiver fits only one way. If the SFP does not install under
gentle pressure, flip it over and try again.