Installation guide

5–Fibre Channel Over IP
Configuring FCIP
ISR651101-00 C 5-13
To verify the listen port number, run the following command (from a Linux system),
where the IP address specified is that of the remote router’s management port:
rpcinfo -p <IP address>
Look for the following program numbers:
The output of the rpcinfo command should be similar to the following. The
numbers in the Port # column (714, 835, and 896 in these examples) are the
port number(s) that you need to unblock.
Program # Port #
--------- ------
351517 1 udp 714
351517 1 tcp 714
351516 1 udp 714
351516 1 tcp 714
351514 1 udp 835
351514 1 tcp 835
351515 1 udp 896
351515 1 tcp 896
Table 5-3. Ports Requiring Unblocking
Port Description
20/TCP FTP—data
21/TCP FTP—control (command)
23/TCP Telnet protocol—unencrypted text communications
111/TCP,UDP Sun Remote Procedure Call (RPC)
161/TCP,UDP Simple Network Management Protocol (SNMP)
835/TCP,UDP Port number on which the server listens for user requests
Router Program Number
iSR6142 351514
iSR6200 351515
351516
351517