Installation guide

1–Introduction
iSR6200 Router Blades
ISR651101-00 H 1-9
Figure 1-8. iSCSI (GE) Ports on the iSR6240 Router Blade
Router Blade LEDs
Each chassis blade provides LEDs and connectors that face the front of the
chassis and may also provide expansion ports, depending on its model. The
router blade LEDs shown in Figure 1-9 provide information about the router’s
operational status. These LEDs include the heartbeat LED, the system fault LED,
and the input power LED. The blade also includes a recessed beacon indicator
used to locate the physical blade monitored using SANsurfer Router Manager.
Figure 1-9. Router Blade LEDs
Heartbeat LED (Green)
The heartbeat LED blinks once per second as long the router firmware is
operational.
System Fault LED (Amber)
The system fault LED lights up to show that a fault exists in the router firmware or
hardware. Fault conditions include power on self-test (POST) errors and
over-temperature conditions. The LED shows a blink code for POST errors and
the over-temperature condition. See Figure 1-9 and Table 1-3.
Table 1-3. System Fault LED Blink Patterns
System
Fault LED
Condition
OFF OK (operational)
1 Blink Beacon; synchronized with the heartbeat LED
3 Blinks System error
Activity Link Status
MGMT IOIOI
FC1 FC2 GE1 GE1
GE4 GE3 iSR6240
Intelligent Storage Router
iSR6200 System
10GbE1 iSR6250
Intelligent Storage Router
10GbE2
Beacon IndicatorHeartbeat LED System Fault LED Power LED