Installation guide

15
5. If round-trip latencies are greater than 50 ms or WAN line rate is DS-3 (4500Mbps) or less, enable
compression.
6. Except for mapping of tape devices, select Load Balancing.
7. Confirm the summary of this change.
8. Enter the local router’s password.
The status screen shows the status of this operation.
Using the CLI:
■ Issue the remotemap add command.
Step 12. Locate the Blade Serial Number for the License Key Activation
The serial number of each blade is required for activating the router license key on the License Key Activation form. You
can locate the blade serial number (SN) with the following methods:
■ Use the QLogic utilities, either the CLI or SANsurfer Router Manager (GUI). (Recommended method; most
reliable)
■ View the serial number marked on the bottom of blade.
Serial Number Formats
It is very important that you enter the blade’s exact and entire serial number (case-sensitive). If any part of the serial
number is different or truncated, the generated license key will not work. The QLogic iSR6200 products have 10-digit
alphanumeric serial numbers, for example:
SN: 0951F00579
Using the CLI to Locate the Serial Number
To find the serial number of your blade from the command line, follow these steps:
1. Telnet into the iSR6200, and then start the CLI.
2. Log in as guest; the default password is password.
3. Issue the show chassis command.
4. Under Blade x Information, locate and write down the serial number for each blade.
In the following example, the two blade serial numbers are shown in bold blue text:
iSR6200 login: guest
Password:
******************************************************
* *
* ISR6200 *
* *
******************************************************
iSR6200 #> show chassis
Chassis Information
---------------------
Product Name iSR6200