Installation guide

B–Log Messages
Error Log Messages
B-20 ISR651103-00 C
106589 #%d: QLIoctlEnable: Adapter disabled
93
The Fibre Channel processor was disabled by an IOCTL
request to the driver.
106590 #%d: QLIoctlEnable: Initialize FW error
94
The Fibre Channel processor firmware failed
initialization. The request to initialize was received by the
driver in an IOCTL request.
106592 #%d: QLIoctlRunDiag: Diagnostic loopback command
failed %x
%%x%x
96
The Fibre Channel processor failed the external loopback
test.
106593 #%d: QLIoctlDisable: Re-initialize adapter
failed
97
The Fibre Channel processor failed to re-initialize in
response to an IOCTL disable request.
106595 #%d: QLUtmReceiveIo: Invalid VP Loop Id 0x%x
99
Invalid Virtual Port loop ID.
106803 #%d: QLIsrEventHandler: Link down (%x)
307
The Fibre Channel processor reported a link down
condition.
106813 #%d: QLIsrEventHandler: Unexpected async event
(%x), MB1=%x, MB2=%x, MB3=%x, MB4=%x, MB5=%x,
MB6=%x, MB7=%x
317
The Fibre Channel processor reported an unexpected
asynchronous event. The mailbox registers provide
status, event code, and data related to the event.
106846 #%d: QLProcessResponseQueueFS: TRB is NULL: %d
350
FCIP Response queue entry TRB pointer is NULL.
106853 #%d: QLTimer: Link error count (0x%x) exceeded,
link down
357
The driver has determined that the Fibre Channel link is
unreliable and unusable due to the number of errors
encountered. The link has been taken down.
106912 #%d: QLReserveLoopId: out of loop Ids
416
The Fibre Channel processor was unable to obtain the
number of loop IDs required. This failure occurs only
when the Fibre Channel processor is running multi-ID
firmware.
Table B-10. Fibre Channel Driver—Error Log Messages (Continued)
ID Log Messages No. Description