Installation guide

B–Log Messages
Error Log Messages
ISR651103-00 C B-11
41107 QLBA_DisplayInitiatorOperationStatus: Transport
Error, Status 0x%.2x
147
Process control block status indicates that a transport
error (protocol) occurred during an initiator operation.
41111 QLBA_DisplayInitiatorOperationStatus: Data
Overrun, Status 0x%.2x
151
Process control block status indicates that a data overrun
error occurred during an initiator operation.
41234 QLIS_LoginPduContinue: Operation failed.
Initiator 0x%x, TPB status 0x%x
274
iSCSI login failed between receipt of PDU and request
for the data segment.
41238 QLKV_ValidateLoginTransitCsgNsgVersion failed
(status 0x%x)
278
iSCSI login failed due to unsupported version number in
received login PDU.
41257 QLIS_LoginPduContinue: Invalid initiator name.
Initiator:
297
iSCSI Login PDU contains invalid initiator name. The
format and character set used to form the initiator name
is invalid.
41265 QLIS_LoginPduContinue: Target not configured for
Portal
305
iSCSI target login was attempted to a portal (iSCSI1 or
iSCSI2) on which the target is not presented.
41267 QLIS_LoginPduContinue: Target not found. Target
name:
307
iSCSI Login PDU received for a target with a target name
unknown to the router.
41268 QLIS_LoginPduContinue: Missing target name
308
iSCSI Login PDU received without a target name for a
normal session.
41270 QLIS_LoginPduContinue: TSIH is 0 but
InitiatorName key/value not provided
310
iSCSI Login PDU received without an initiator name
key/value.
41272 QLIS_LoginPduContinue: CONN_STATE_IN_LOGIN,
Unknown InitTaskTag
312
iSCSI Login PDU received with an incorrect initiator task
tag for a session which is partially logged in. This would
occur if a login PDU other than the initial login PDU used
an initiator task tag which was different than the initiator
task tag provided in the initial login PDU.
Table B-8. Application Modules—Error Log Messages (Continued)
ID Log Message No. Description