Installation guide

ISR651103-00 C 5-1
5 Removal and Replacement
This chapter provides removal and replacement procedures for the following field
replaceable units (FRUs):
 SFP transceivers
 iSR6152 router
Removing and Replacing SFP Transceivers
You can remove and replace the SFP transceivers while the router is operating
without damaging the router or the transceiver. However, doing so interrupts
transmission on the affected port until the transceiver is installed.
 To remove a transceiver, gently press the transceiver into the port to
release the tension, and then pull the release tab or lever and remove the
transceiver. Different transceiver manufactures have different release
mechanisms. Consult the documentation for your transceiver.
 To install a transceiver, insert the transceiver into the port and gently press
until it snaps in place.
Removing and Replacing the Router
Before you can remove and replace the router, you must turn off the power to the
router and disconnect its power cable. The router loses all the Fibre Channel and
Ethernet connections.
Removing the Router
Perform the following steps, as applicable, to remove a router.
NOTE:
The SFP transceiver fits only one way. If the SFP does not install under
gentle pressure, flip it over and try again.