Installation guide

3–Installation
Installing the Firmware
ISR651103-00 C 3-11
To configure the router using the command line interface:
1. Open a command window according to the type of workstation and
connection:
 Ethernet (all platforms). Open a Telnet session with the default router
IP address and log into the router with the default account name and
password (guest/password) as follows.
telnet 10.0.0.1
user name – guest
password – ********
 Serial. On Windows, open the HyperTerminal application. The next
steps may vary according to the version of Windows you use:
a. On the Windows Start menu, point to Programs, Accessories,
HyperTerminal, and then click HyperTerminal.
b. Select the connection you created earlier, and then click OK.
 Serial. On Linux, open a command window and issue the following
command:
minicom
2. Open an Admin session and issue the set mgmt command to set up the
management interface. See the iSR6152 Router CLI User's Guide for
command descriptions.
QRouter #> admin start
Password – ******
QRouter (admin) #> set mgmt
Cabling Devices to the Router
Connect cables to the SFP transceivers and their corresponding devices. Devices
can have either SFP or gigabit interface converters (GBIC). Lucent (LC)-type
duplex fiber optic cable connectors are designed for SFP transceivers, while
subscriber-connector (SC)-type connectors are designed for GBICs. Choose the
fiber optic cable with the connector combination that matches the device you are
connecting to the router.
Installing the Firmware
The router comes installed with the current firmware. As new firmware becomes
available, you can upgrade the firmware from the management workstation. You
can use Router Manager or the CLI to install new firmware.