Installation guide

1–Introduction
Fibre Channel Ports
1-6 ISR651103-00 C
 Disables the GbE ports and sets the IP address to 0.0.0.0.
 Erases all presentations.
 Erases all discovered initiators and targets.
Fibre Channel Ports
The iSR6152 router has two Fibre Channel ports, labeled FC1 and FC2, as shown
in Figure 1-4.
Figure 1-4. Fibre Channel Ports
Each port is served by a small form-factor pluggable (SFP) optical transceiver and
is capable of 2Gbps, 4Gbps, or 8Gbps transmission. SFPs are hot-pluggable: you
can remove or install a transceiver while the router is operating without harming
the router or the transceiver. Fibre Channel ports can self-discover both the
connection type and transmission speed when connected to public devices or
switches.
Fibre Channel Port LEDs
The Fibre Channel port LEDs are located to the right of their respective ports and
provide status and activity information. Each port has three LEDs:
 The amber (top) LED shows activity for data passing through the port at
2Gbps speed.
 The green LED (middle) shows activity for data passing through the port at
4Gbps speed.
 The yellow LED (bottom) shows activity for data passing through the port at
8Gbps speed.
2Gbps Activity LED
4Gbps Activity LED 8Gbps Activity LED