Installation guide

1–Introduction
Chassis LEDs
ISR651103-00 C 1-3
Chassis LEDs
The chassis LEDs shown in Figure 1-2 provide information about the router’s
operational status. These LEDs include the input power LED, heartbeat LED, and
the system fault LED. To apply power to the router, plug the power cord into the
router AC power receptacle and into a 100 VAC to 240 VAC, 50 Hz to 60 Hz
power source.
Figure 1-2. Chassis LEDs
Input Power LED (Green)
The power LED shows the voltage status at the router logic circuit board. During
normal operation, this LED lights up to show that the router logic circuit board is
receiving the DC voltage from the power supply.
Heartbeat LED (Green)
The heartbeat LED blinks once per second as long the router firmware is
operational.
System Fault LED (Amber)
The system fault LED lights up to show that a fault exists in the router firmware or
hardware. Fault conditions include POST errors and over-temperature conditions.
The LED shows a blink code for POST errors and the over-temperature condition.
See Figure 1-2 and Tabl e 1- 1.
Table 1-1. System Fault LED Blink Patterns
System
Fault LED
Condition
Off Okay (operational)
3 Blinks System error
4 Blinks Management port IP address conflict
5 Blinks Over temperature
Power LEDHeartbeat LED System Fault LED