Installation guide

iSR6152 Intelligent Storage Router
Installation Guide
Glossary-6 ISR651103-00 C
NL_Port
Node loop port. A port capable of
arbitrated loop functions and protocols. An
NL_Port connects through an arbitrated
loop to other NL_Port and at most a single
FL_Port. NL_Ports handle creation, detec-
tion, and flow of message units to and
from the connected systems. NL_Ports are
end ports in virtual point-to-point links
through a fabric, for example NL_Port to
F_Port to F_Port to N_Port using a single
Fibre Channel fabric switch. In the
absence of a fabric switch FL_Port,
NL_Ports can communicate with other
NL_Ports in virtual point-to-point links
through an FC_AL open loop circuit often
through FC_AL (Arbitrated Loop) hub or
loop switch devices. See: E_Port, F_Port,
FL_Port, G_Port, N_Port.
network time protocol
See NTP.
non-volatile random access memory
See NVRAM.
NTP
Network time protocol. NTP is used for
distributing the Coordinated Universal
Time (UTC) by means of synchronizing the
clocks of computer systems over
packet-switched, variable-latency data
networks.
NVRAM
Non-volatile random access memory.
NVRAM is a type of memory that retains
data (including configuration settings)
even when power is removed. You can
configure NVRAM settings manually or
restore them from a file.
path
A path to a device is a combination of a
adapter port instance and a target port as
distinct from internal paths in the fabric
network. A fabric network appears to the
operating system as an opaque network
between the adapter (initiator) and the
target.
Because a path is a combination of an
adapter and a target port, it is distinct from
another path if it is accessed through a
different adapter and/or it is accessing a
different target port. Consequently, when
switching from one path to another, the
driver might be selecting a different
adapter (initiator), a different target port, or
both.
This is important to the driver when
selecting the proper method of failover
notification. It can make a difference to the
target device, which might have to take
different actions when receiving retries of
the request from another initiator or on a
different port.
point-to-point
Also FC-P2P. Two Fibre Channel nodes
directly connected (not in a loop).
port
Access points in a device where a link
attaches. There are four types of ports, as
follows:
 N_Port—a Fibre Channel port that
supports point-to-point topology.
 NL_Port—a Fibre Channel port that
supports loop topology.
 FL_Port—a port in a fabric where an
N_Port can attach.
 FL_Port—a port in a fabric where an
NL_Port can attach.