Installation guide

B–Log Messages
Fatal Log Messages
ISR651103-00 C B-27
Fibre Channel Driver
Table B-14 lists the fatal log messages common to both Fibre Channel ports, 1 (FC1) and 2 (FC2). Log messages
beginning with #0 denote Fibre Channel port 1 (FC1); log messages beginning with #1 denote Fibre Channel port 2
(FC2).
70836 #%d: QLStartFw: Invalid Fw loader state 0x%x
1204
iSCSI firmware loader invalid state.
70837 #%d: QLStartFw: Load Fw loader timeout
1205
iSCSI failed to load firmware in time allotted.
Table B-14. Fibre Channel Driver—Fatal Log Messages
ID Log Message No. Description
102419 #%d: qlutm_init: Diagnostic failed, port 1
invalid SRAM
19
FC1 processor SRAM test failed.
102420 #%d: qlutm_init: Diagnostic failed, port 1 POST
failed
20
FC1 processor power-on self-test (POST) failed.
102421 #%d: qlutm_init: Diagnostic failed, port 2
invalid SRAM
21
FC2 processor SRAM test failed.
102422 #%d: qlutm_init: Diagnostic failed, port 2 POST
failed
22
FC2 processor POST failed.
102423 #%d: qlutm_init: Failed to return diagnostic
result to Bridge
23
Fibre Channel processor failed to return diagnostic
results.
102656 #%d: QLInitializeAdapter: Reset ISP failed
256
Fibre Channel processor failed reset.
Table B-13. iSCSI Driver—Fatal Log Messages (Continued)
ID Log Message No. Description