User`s guide

3 – Managing the Router
FC Ports
3-12 SN0054660-00 A
S
 Actual Connection Mode – Displays the port’s connection mode, either
Point-to-Point or Loop.
 Actual Data Rate – Displays the port’s operating data rate when online,
either one gigabit per second (1 Gbps) or two gigabits per second (2
Gbps).
FC Port Advanced Configuration Tab
When you select the Advanced Configuration tab for the selected FC port, the
system displays the Advanced Configuration tabbed page (see Figure 3-9).
Figure 3-9 FC Port Advanced Configuration Tab
The FC port Advanced Configuration tab provides the following parameters:
 Connection Options – Displays the connections. When an FC port is not
part of an FCIP route, it only operates in FC loop mode.
 Data Rate – Displays a drop-down list that lets you set the data rate: Auto, 1
Gbps, or 2 Gbps. The default is Auto. If you change this setting, you must
click Save (at the bottom of the page) for the change to take effect.
 Frame Size – Displays a drop-down list that lets you set the frame size:
2048, 1024, or 512 bytes. The default is 2048. If you change this setting, you
must click Save (at the bottom of the page) for the change to take effect.
 Execution Throttle – Displays a drop-down list that lets you set the
execution throttle: 16, 32, 64, 128, or 256. The default is 64. When you
change this setting, you must click Save (at the bottom of the page) for the
change to take effect.