User`s guide

2 – Using the Graphical User Interface (GUI)
Menu Bar
2-6 SN0054660-00 A
S
 Map Local Initiator/Target Wizard – Launches the Map Local Wizard,
which allows you to map a local initiator to a local target (see page 4-13).
 Unmap Local Initiator/Target Wizard – Launches the Unmap Local
Wizard, which allows you to delete a local initiator from a local target
mapping (see page 4-20).
 Add Remote Router Wizard – Launches the Add Remote Router Wizard,
which allows you to assign local router to a remote router as peers (see
page 4-25).
 Remove Remote Router Wizard – Launches the Remove Remote Router
Wizard, which allows you to remove a local-to-remote router peer
assignment (see page 4-30).
 Map Remote Initiator/Target Wizard – Launches the Map Remote Wizard,
which allows you to map an initiator to a target device, one of which is on a
remoter router (see page 4-33).
 Unmap Remote Initiator/Target Wizard – Launches the Unmap Remote
Wizard, which allows you to delete an initiator-to-target device mapping (see
page 4-20).
 Discover iSCSI Target – Launches the Discover iSCSI Target Wizard,
which allows you to specify the IP address of the iSCSI Target to be
discovered. The target is added to the discovered targets list (see section
page 4-42).
 FCIP Route Add – Launches the (Fibre Channel over IP) FCIP Route Add
Wizard, which allows you to select the resources used for the route, the IP
address of the remote FCIP peer, IP parameters, Virtual Lan (VLAN)
support, compression, and bandwidth limit (see page 4-45).
 FCIP Route Remove – Launches the FCIP Route Remove Wizard, which
allows you to remove an existing FCIP route, freeing the resources (FC and
GE ports) used by the route (see page 4-51).