User`s guide

4 – Using the Wizards
FCIP Route Add Wizard
4-50 SN0054660-00 A
S
 FCIP SW Compression – Provides a drop-down box you can use to
enable or disable FCIP compression. The default is disabled.
 Bandwidth (Mbit/sec) – Provides a text field in which you can enter
the maximum bandwidth (in megabits per second) used by the GigE
port during transmits. The range of values supported is 1 to 1000
megabits per second. This setting allows you to limit the bandwidth
used by the FCIP route so as to not consume all the available link
bandwidth. For example, if the slowest link in the WAN being used is a
DS-3 link, the maximum available bandwidth is 45 megabits per
second. To limit the FCIP route to 33% of the overall link bandwidth set
the bandwidth to 15 megabits per second.
10. After setting the FCIP parameters, click Next to continue or click Cancel to
quit the wizard.
The Security Check dialog box requests the administrator password, as
shown in Figure 4-59.
Figure 4-59 FCIP Route Add Wizard—Security Check Dialog Box
11. Type the appropriate password, then click OK to confirm adding the FCIP
route.
The Add FCIP Route Complete dialog box lets you know when the
configuration is complete, as shown in Figure 4-60.
Figure 4-60 FCIP Route Add Wizard—Completed Dialog Box
12. Click OK to exit the dialog box.
NOTE:
This dialog box may take a few seconds before appearing.