User guide

2–FastFabric TUI Menu
Fast Fabric IB Chassis Setup/Admin Menu
IB0054607-01 A 2-11
Get Basic Chassis Configuration
(Switch) The Get Basic Chassis Configuration supports a new feature to
retrieve basic information from chassis such as syslog, NTP configuration, time
zone information, MTU Capability, VL Capability, VL Credit Distribution, Link Width
and node description. The following is an example of the information retrieved:
TEST SUITE getconfig CASE (getconfig.i12k71f.getconfig) get i12k71f
i12k71f:
Syslog Configuration : Syslog host set to: 192.168.2.15 port 514
facility 22
NTP : Configured to use NTP server: 10.32.2.3
time zone : Current time zone offset is: -5
MTU Capability : 2048 Bytes
VL Capability : 2 VLs
VL Credit Distribution : 4
LinkWidth Support : 4X
Node Description : i12k71f
Auto clear status : Auto clear is disabled
PASSED
Check Status of IB Ports
(Switch or All): Check Status of IB Ports allows the state and error counts of all
ports to be checked and reviewed.
Based on the answers to the prompts shown below either the
showallports -C
or the iba_report command will be used.
Would you like to perform fabric error analysis? [y]:
Clear error counters after generating report? [y]:
Would you like to perform fabric link speed error analysis?
[y]:
Check for links configured to run slower than supported? [n]:
Check for links connected with mismatched speed potential?
[n]:
(All): The answer to Would you like to perform fabric error
analysis
selects whether iba_report -o errors should be run. If the user
answers
y, the Clear error counters after processing report
question is asked. If the user answers y, the -C option will also be used on
iba_report to clear the port error counters after doing the error analysis.