Datasheet

QLogic Host Channel Adapter and QLogic OFED Software Install Guide
QLogic OFED Version 1.4
IB0056101-00 H v
S
Added a last step to restart.
Updated the NOTE about setting datagram mode.
“Configure the IPoIB Network Interface” on
page 6-2
In the first paragraph, updated information about
where the package can be installed/enabled, and
when OpenSM is not needed.
Added second paragraph about the Installer tool.
Added third paragraph about rpm install with
OpenSM.
Added last paragraph about where to find more
information about OpenSM.
“OpenSM” on page 6-3
Updated the second paragraph to list with which
OCS downloads SRP is available.
“SRP” on page 6-4
New section “Using QLogic SRP” on page 6-4
Added second, third, and fourth paragraphs to dis-
cuss the VNIC driver and the virtual Ethernet inter-
face.
Updated the output for the
ib_qlgc_vnic_query command in Step 1.
Added that the command in Step 5 must be done
as a root user.
“Configuring and Administering the VNIC Inter-
face” on page 6-6
Added instructions for setting up Intel
®
MPI. “MPI over uDAPL” on page 6-13
Added more details about setting the switch MTU
default to 4K.
“Other Configuration: Changing the MTU Size” on
page 6-14
Changed section name from Configuring the
ib_ipath driver to Managing the Infinipath driver.
Updated section: this driver now runs as a system
service.
“Managing the InfiniPath Driver” on page 6-14
Split Stopping and Starting the InfiniPath Software
into two sections.
“Configure the InfiniPath Driver State” on
page 6-15
“Configure the InfiniPath Driver State” on
page 6-15
Changed commands for checking the configura-
tion state and enabling/disabling the driver.
“Configure the InfiniPath Driver State” on
page 6-15
Removed paragraph about OpenSM.
Changed commands to restart the driver.
Noted that you do not have to be a root user to run
the command to determine which InfiniPath and
OpenFabric modules are running.
“Start, Stop, or Restart InfiniPath” on page 6-15