Operation Manual

STEP 16

STEP 18

STEP 26

STEP 27

STEP 3

STEP 23

STEP 17

5/16"

STEP 19

STEP 20STEP 20

STEP 21

STEP 25

15. Raise the wick to its highest position and tighten the

wing nuts in several steps.

16. Check the wick height. It should be 5/16 above the collar.

17. Check for the correct clearance between wick holder

and draft tube. It should be the same all around.

18a. Reinstall the tip-over switch assembly by pushing the

extinguish knob.

18b. Connect the 3 connectors (3EA) with the circuit board.

18c. Remove the connector (1EA) from the ignitor.

19. Check the function of the tip-over safety stop by push-

ing the extinguish button to upset the pendulum.

20. Reinstall the automatic ignition assembly.

21. Reinstall the wind cover A / B.

22. Reinstall the cabinet.

23. Tighten the 5 screws on the cabinet and reinstall the

sensor at the back of the cabinet.

24. Reinstall the combustion chamber and the fuel tank.

25. Reinstall the wick adjusting knob. Close the front plate.

Install the batteries in the battery case and fill the fuel

tank with Qlima Premium Quality Fuels. Set the tank

into the heater and wait at least 60 minutes for the

new wick to fully saturate with the fuel.