Operation Manual

46
Burner flame goes
off immediately
after ignition
Low gas pressure Let the pilot flame stay lit
for 10 minutes before set
-
ting variable knob to LO.
Emitter glows une
-
ven
Blockage in burner
injector
Clean or replace burner
injector
Base is not on a leveI
surface
Place heater on a IeveI
surface
Low gas pressure Replace cylinder with a new
cylinder.
Thick black smoke Blockage in burner Turn off the heater and Iet
it cool.
Remove blockage and clear
burnerinside and outside.
Carbon bulld-up Dirt or film on reflec
-
tor and flame screen
Clean reflector and flame
screen.
END OF LIFE TIME
If it is decided that the gas heater is not to be used any more, it is recom-
mended that it be disconnected from the gas container. Also cut the rubber
hose. If children play with the heater, make sure that dangerous parts are
removed.
Never dispose of non-biodegradable products in the environment, but dis-
pose of them in accordance with current national legislation. At the end of
its lifetime, the product must not be disposed of as urban waste. It must be
taken to a special local authority differentiated waste collection center or to
a dealer providing this service.
Disposing of a household appliance separately avoids possible negative con-
sequences for the environment and health deriving from inappropriate dis-
posal and enables the constituent materials to be recovered in order to make
significant savings in energy and resources. As a reminder of the need to dis-
pose of household appliances separately.
WARRANTY PROVISIONS
The appliance is supplied with a 24-month guarantee, commencing on the
date of purchase. All material and manufacturing defects will be repaired or
replaced free of charge within this period. The following rules apply:
1. We expressly refuse all further damage claims, including claims for collate-
ral and/or consequential damage.
2. Repairs to or replacement of components within the guarantee period will
not result in an extension of the guarantee.
3. The guarantee is invalidated if any modifications have been made, non-
genuine parts are fitted or repairs are carried out by third parties.
4. Components subject to normal wear, such as filters, batteries, lamps and
heating elements are not covered by the guarantee.
5. The guarantee is valid only when you present the original, dated purchase
invoice and if no modifications have been made to it.
6. The guarantee is invalid for damage caused by neglect and/or by actions
that deviate from those in this instruction booklet.
4
man_PGU2013_('18)_V1.indd 46 10-01-18 14:56