Operation Manual

came with your regulator.

• Replace the cylinder.

• Make sure there is no flame. Only when no flame: remove the plug or seal

cap from the cylinder valve.

• Check for the presence and good state of the gasket before connecting the

regulator to the new cylinder

• Check that the regulator seal is correctly fitted and able to fulfil its function.

• Perform leak test using soapy water solution.

WARNING: only change the gas cylinder in a amply ventilated area, away

from any ignition source (candle, cigarettes, other flame producing applian-

ces, ...).

STORAGE

• Make sure the heater is in off position

• Always close the valve of the gas cylinder after use or in case of a disturban-

ce.

• Disconnect the gas container from the gas heater.

• Store the gas container in a well-ventilated room. Position it far away from

inflammable, explosive or hot materials and preferably not in the home. In

addition it should never be stored in the basement or attic.

• Cylinder must be stored out of the reach of children.

• Disconnected cylinder must have threaded valve plugs tightly installed and

must not be stored in garage or any other enclosed area. Only store in venti-

lated area!

• Storage of heater indoors is permissible only if the cylinder is disconnected

and removed from the heater.

• Check the tightness of the gas valve and for damage. If you suspect a dama-

ge, have it changed by your gas dealer.

• Never store liquid gas cylinder in a sub-terrain, or at places without adequate

air ventilation.

CLEANING AND CARE

Warning: Make sure the heaer is in off position and is cool!

Warning: Do not clean heater with cleaners that are combustible or corrosive.

• Wipe off powder coated surfaces with soft, moist rag and soap water.

• Remove debris, spider and insect nests from ventilation opening of the cylin-

der enclosure, control compartment, burner and circulation air passageways

of the heater with heavy duty pipe cleaner or compressed air to keep appli-

ance clean and safe for use.

• Never clear ports or other openings with toothpicks or other article that will

break and block the ports.

• If carbon deposits develop, remove the reflector and flame screen and clean

them with soap water.

• Do not paint the flame screen, control panel or reflector.

• Cover the burner unit with the optional supplied protective cover when the

heater is not in use. Wait until the heater is cool before covering.

man_PGU2013_('18)_V1.indd 44 10-01-18 14:56