Operation Manual

19
4
OPERATION
Connect the power cable to a suitable socket (refer to rating label) that is located
in a safe, dry area.
• The switch on the heater head is used to control the one heat setting.
(I) for 900w, (II) for 1200W, (I&II) for 2100W.
The 0 = off
• Although the patio heater is shower proof, do not use when raining or in
wet conditions.
• Always disconnect the power cable from the electrical supply, when the patio
heater is not in use
• Dark points may exist on the surface of the heating elements during the first
few minutes after it is turned on. This is normal, and will not affect the per-
formance of the unit.
CARE AND MAINTENANCE
• When disconnected from the electrical supply, clean the outside of the patio
heater with a damp cloth. Never use corrosive or solvent cleaners or immerse
in water.
• Any maintenance or repairs including replacing the halogen tube should only
be carried out by a qualified electrician or by a Qlima recommended service
center.
TROUBLE SHOOTING
If the heater will not operate, please check the following before seeking repair of
service:
• Check if the power cord is plugged into an electrical outlet, if not plug in.
• See step 4: make sure the the power cord connection in the pole is in good
condition.
• Check if electricity to the main fuse is working.
• Make certain the power switches are turned on. If not, choose a setting.
PEP 2021E PEP 1021
Max. Power output/
input
2100W 2100W
Power supply 220-240V / 50 Hz / 1 ph
Power output steps 3 steps: 900 / 1200 / 2100 W
Height adjustable 160 – 205 cm X
IP rating IP x4
Current 9.1 A 9.1 A
Weight 14 kg 14 kg
Radiation range (*) 4.2 m 4.2 m
(*) for reference only