Operation Manual

>1800

>1000

>500

>1800

>500>500

Hanging Installation

• Mark and drill 2 Ø8 holes on the ceiling as per diagram.

• Insert plastic plugs (#1) 2pcs into the holes.

• Screws (#3) 2pcs longer ones go through the mounting pole (#2) and fasten

on the ceiling.

• Insert the hanging lines (#4) 2pcs into the line holes (#A) of mounting pole

(#2). Length can be manually adjusted by pushing the switch of hole (#A).

• Clip the power cord on the cable clip (#B) of mounting pole (#2).

Wall/Ceiling Mounted Installation

• Mark and drill 4 Ø8 holes on the wall or ceiling as per diagram.

• Insert plastic plugs (#1) 4pcs into the holes.

• Screws (#3) 4pcs shorter ones go through the mounting bracket (#2) 1pc and

fasten on the wall or ceiling.

• Parallel insert the bracket (#2) into the sheet (#4), fasten with screw (#5) 1pc.

• Fasten the screw (#A) of the bracket (#2) after adjust the suitable angle for

using the heater.